Wiring help

Connecting the osPID hardware to the real world

Wiring help

Postby dchris01 » Thu Apr 19, 2012 1:12 am

Can anyone guide me in the right direction on wiring up my IR 250w plate to osPID and a Fotek SSR and to main power I am a noob at this kind of stuff here is how far I have got to http://img23.imageshack.us/i/imageqdjr.jpg/
dchris01
 
Posts: 17
Joined: Sun Mar 11, 2012 10:18 pm
Location: Ireland

Re: Wiring help

Postby meurig » Thu Apr 19, 2012 8:51 am

I'm sure someone will step in with a ospid specific answer, but it looks from your picture that you have that side of things covered.

When wiring the hotplate the SSR acts like a switch, so you'd wire up the hot plate to the mains as normal, but with the SSR on either the live or neutral wires.

Ignoring the controller side of things, these pictures should give you an idea:
http://www.altec.cc/images_eng/AL808/AL808_SSR_EN.gif
http://www.delabs-circuits.com/cirdir/t ... ac-ssr.png
meurig
 
Posts: 5
Joined: Wed Apr 18, 2012 4:30 pm

Re: Wiring help

Postby Brett » Fri Apr 20, 2012 11:44 am

but with the SSR on either the live or neutral wires.

it's safer to put the SSR on the live wire. this way the flow of electricity is interrupted BEFORE it goes out into the hot plate. if you have it on the neutral wire, the hot plate has the ability to shock/short-circuit even when the SSR is off.
User avatar
Brett
Site Admin
 
Posts: 99
Joined: Fri Mar 09, 2012 10:05 pm
Location: Boston


Return to Setup & Troubleshooting

Who is online

Users browsing this forum: No registered users and 0 guests